Getting started
5.8
Take enough time to familiarise yourself with the use of the system in combination with your
phone. First of all, make a few calls to determine the ideal volume and the best voice pick-up di-
rection before using the system in traffic. The best way of optimising conditions of use is to park
your car in a quiet place especially for this purpose. It is also helpful if another phone user can
take some time to assist you when making test calls.
On / Off function
5.8.1
Turning the ignition key simultaneously activates the hands-free system. Immediately after the
system is activated, the two LEDs blink 4 times. This indicates that the system is in standby
mode and ready to make a connection. In order to use the system for phone calls, a Bluetooth
®
compatible phone must be coupled to the EGO TS system. How this is done is explained in detail
in the following sections. When the ignition is turned off, the hands-free system also shuts
down. If the ignition is turned off during a call, phone ability is maintained and the system is shut
down only after the call has been completed.
Coupling
5.8.2
As long as no device is connected, the system is visible for all Bluetooth
-
®
devices.
The device to be used (mobile phone, PDA, etc.) must be logged in to the system.
-
The Bluetooth
®
search and coupling are carried out by the device.
The name of the system is EGO TS.
The PIN has a default setting of 0000.
-
Bei erfolgreicher Verbindung/Kopplung leuchten beide LED‘s dauerhaft.
-
It can be 8 Bluetooth
-
®
phones be connected.
Automatic coupling
5.8.3
If a phone is already connected with the system, the EGO TS tries to couple to this phone. When
a connection has been successfully made, the two LEDs are permanently on. The connection is
always made to the most recently coupled phone. If this phone is out of range, the system will
search for other phones registered in the system. When the search is successful, the connection
to this phone is completed automatically. If the search process was unsuccessful, the system
reverts to the coupling mode. This enables manual connection from the phone.
LED status
5.8.4
Green blinks in short intervals → no device connected
-
Both permanently on → device is connected
-
Red on and green blinks periodically → active call
-
14
|
15
