FUNAI VIP-5000HC MK12, Руководство по обслуживанию

Страница: 10 / 76

CABINET DISASSEMBLY INSTRUCTIONS
1. Disassembly Flowchart
This flowchart indicates the
disassembly steps to gain
access to item(s) to be serv-
iced. When reassembling,
follow the steps in reverse
order. Bend, route, and
dress the cables as they
were originally.
Disassembly Method
ID/
LOC.
No.
PART
REMOVAL
Fig.
No.
REMOVE/
*UNHOOK/UNLOCK/
RELEASE/UNPLUG/
DESOLDER
Note
[1] Top Case 1 3(S-1) -
[2]
Front
Assembly 2 *3(L-1), *4(L-2)
-
[3]
Deck
Assembly 3 6(S-2), Spacer
*(CN251,
CN501 [ VIP-
5000LR MK12 ],
CN502, CN503,
CN504)
1, 2
[4]
REC Arm
Assembly
[ VIP-
5000LR
MK12 ] 3 ----------
-
[5] Main CBA 4 *(L-3), *2(L-4) -
[6]
Function
CBA 4 Desolder
3
↓
➀
↓
➁
↓
➂
↓
➃
↓
➄
Reference Notes
CAUTION: Locking Tabs (L-1) and (L-2) are fragile. Be
careful not to break them.
1. Remove six Screws (S-2) and the spacer. Then
slowly lift the Deck Assembly up. Lifting Deck As-
sembly disconnects five Connectors (CN251
CN501 [ VIP-5000LR MK12 ], CN502, CN503,
CN504). (Fig. 3)
2. Before installing the Deck Assembly, be sure to
place the pin of LD-SW on Main CBA as shown in
Fig. 5. Then, install the Deck Assembly while align-
ing the hole of Cam Gear with the pin of LD-SW, the
shaft of Cam Gear with the hole of LD-SW as shown
in Fig. 5.
3. After removing the Main CBA, desolder from bottom
of the Main CBA as shown in Fig. 4 to remove the
Function CBA.
(S-1)
[1]Top Case
Fig. 1
[1] Top Case
[2] Front Assembly
[6] Function CBA
[3] Deck Assembly
[4] REC Arm Assembly
[5] Main CBA
[ VIP-5000LR MK12 only ]
1 : Identification (location) No. of parts in the figures
2 : Name of the part
3 : Figure Number for reference
4 : Identification of parts to be removed, unhooked, un-
locked, released, unplugged, unclamped, or
desoldered.
P=Spring, L=Locking Tab, S=Screw,
CN=Connector
*=Unhook, Unlock, Release, Unplug, or Desolder
e.g. 2(S-2) = two Screws (S-2),
2(L-2) = two Locking Tabs (L-2)
5 :Refer to "Reference Notes."
1-5-1 H85G0DC