Full Vision TRACK MASTER TMX428, Руководство пользователя

Страница: 54 / 83

Preventive Maintenance Ch. 7 TRACKMASTER
52
TMX428 Owner’s Manual
317-160-284 Rev 6
February 2021
Semiannual Maintenance

Evaluate the condition of the deck and belt.

Belt adjustment needs to be performed to assure proper belt alignment.

Check running belt adjustment.

Check drive belt tension adjustment.

Clean and lubricate the treadmill elevation screw.
NOTE: Use only TRACKMASTER
®
replacement parts. Using other parts may void
your warranty and may cause your treadmill to malfunction.
Belt Cleaning and Inspection
1. Turn treadmill main power switch ON.
2. Start treadmill at 0.5 MPH. With a damp small towel wipe excessive dirt from
running belt keeping the towel in the center of the length of the treadmill. Avoid
getting the towel near the rear roller.
3. When belt is clean stop treadmill.
4. Inspect running belt for tears or nicks. If damaged, replace the belt.
5. Perform Running Belt Tracking Adjustment and Belt Tension Adjustment.
Running Belt Tracking Adjustment
This procedure requires the following tool:
 ¼”
Allen wrench
NOTE: Because this adjustment is not covered under your warranty, it is important
that you review these instructions thoroughly before proceeding.
The patented MasterTrack ® Belt Tracking System significantly reduces the need to
adjust the belt on your treadmill. However, when you operate your treadmill for the
first time, you may need to adjust the tracking of the belt to conform to your floor.
You may also need to adjust the tracking if you move the machine to another
location.
Your running belt should remain centered, although a slight amount of movement to
the left or right is normal during use. Do not allow the running belt to travel all the
way to either side.
To adjust the belt tracking, do the following:
1.
Turn the treadmill’s power switch to ON.
2. Increase the speed to 3.0 MPH.
3. Observe the left side of the running belt as it travels over the rear roller. If the
belt runs to the right side of the roller, turn the right bolt one-eighth turn
clockwise, and turn the left bolt one-eighth turn counterclockwise.
NOTE: When tightening one side of the belt, always loosen the opposite side one-half as
much. This procedure provides finer control, with a smaller impact on the belt
tension.