Full Vision TRACK MASTER TMX428, Руководство пользователя

Страница: 39 / 83

TRACKMASTER Ch. 6 Operating Instructions
317-160-284 Rev 6
TMX428 Owner’s Manual
37
February 2021
Operating Instructions
Before operating the TMX428 and TMX428CP, familiarize yourself with the following safety
control features of the treadmills.
Electrical Safety Tests
The electrical safety of this installation is the responsibility of the customer, not Full Vision, Inc
(TRACKMASTER
®
). In hospitals, contact your in-house biomedical technician, electrician, or
technically qualified personnel. Outside of hospital, contact your hospital affiliation of these
services.
Before using the treadmill, have qualified personnel perform the test listed below:

AC line voltage test to verify the power outlet is properly wired.

Ground continuity test to verify all exposed metal is properly grounded.

Leakage test to verify the equipment passes all applicable leakage tests.
Your in-house biomedical technician, electrician, or technically qualified personnel can find
instruction for performing these tests in the TMX428/TMX428CP Treadmill Service Manual
Operating Controls
The TMX428 treadmill has three operating controls: the power switch, emergency stop switch,
and pull tether. The power switch is located on the rear panel, the emergency stop is located on
the right-hand rail, and the pull tether is located on the left handrail (Optional on opposite side).
Controlling the Treadmill

Turn the power switch ON (
|
).

Use the controlling equipment to start the treadmill, adjust the treadmill speed and grade,
proceed through exercise phases, terminate the exercise session, and turn off the
treadmill. Refer to the appropriate controlling equipment Operator Manual for
instructions.
Power Switch
The power switch controls the AC power to the treadmill. The ON position (
|
) applies power.
The Off position (O) removes power.
Emergency Stop Switch
The emergency stop switch is a safety device for use in emergency situations to stop the
treadmill.
CAUTION: When the Emergency Stop Button (ESB) is engaged or pressed in the closed
position the treadmill
’s running belt
will coast to a stop.
To release the emergency stop switch, turn the push button ¼-turn in clockwise direction or pull
to release. The treadmill will return to 0.0% elevation.
Emergency Stop Switch Check
NOTE: Verify
proper operation of the stop switch assembly every month.

With the belt moving at a relatively high speed, press the emergency stop switch. The
treadmill
’s running belt
will coast to a stop. To release the emergency stop switch, turn
the push button ¼-turn in clockwise direction or pull to release. The treadmill will return
to 0.0% elevation.
CAUTION: When the Emergency Stop Button (ESB) is engaged or pressed in the
closed position the treadmill’s running belt will coast to a stop.

Use the controlling equipment to terminate the exercise session and turn off the treadmill.
6