EASIAIR
®
20
20
THE RPE EXPERTS
7
6. BEFORE USE
Every time before using the device, you should check that:
•
All components are in good conition, with no visible damage (holes, scratches, tears, etc.). Any damaged or
worn parts should be replaced before assembling.
•
The unit has been assembled correctly according to the following instructions (see 7).
•
There is sufficient airflow (see 6.1).
•
The battery is charged (see 6.2/3).
•
The alarm is working (see 6.4).
If any problems arise during the pre-use checks, please consult chapter 9 of this document.
6.1 Testing the airflow
To ensure the Easiair
®
2020 Powered Air Kit is working efficiently,
an airflow test should be taken.
•
Disconnect the air hose from the blower unit.
•
Attach the airflow indicator to the blower unit air outlet.
•
Switch on the device.
•
Holding the unit at eye level in a vertical position, watch to
see if the ball reaches the minimum flow rate level.
6.2 Charging the battery
To ensure the Easiair
®
2020 Powered Air Kit is working at maximum
capacity, it is recommended that a fully charged battery be
equipped at the start of a shift.
To charge the battery:
•
Plug the supplied charger into a power supply of the correct
voltage.
•
Plug the other end into the battery inlet located at the backside
of the battery. (The battery can be charged whether fitted to
or disconnected from the blower unit)
•
The charging state is indicated by an LED light located on the
plug. When red the battery is charging. When green the battery
is charged.
WARNING:
To prolong the life of the battery, it is advisable to
disconnect it from the power supply once fully charged.
