9
BRICK & MASONRY SAW SAFETY WARNINGS (cont.)
• Deceleration time of the cutting disc
- After switching off the machine, the cutting disc
needs 40 seconds before coming to a standstill. Wait until the cutting disc has stopped
completely, then pull the power plug out of the socket outlet and, if necessary, only then
touch the machine’s rotating components.
• Avoid touching the rotating cutting disc at all when the machine is in operation.
• Keep water away from electrical parts of the tool and from persons in the work area!
• Set up the machine on a level, non-slip floor. Make sure that the machine does not wobble.
• Check that the voltage on the rating plate is the same as your supply voltage. Only then
are you to insert the power plug in the socket-outlet.
• Wear safety goggles - Wear ear-muffs - Wear safety gloves suitable for wet
applications.
• Never use cracked diamond cutting discs. Replace immediately.
• Always pull out the power plug before changing the cutting disc.
• Never leave the machine unattended in rooms with children.
• Always pull out the power plug before examining the electric motor compartment system
• Only use cutting discs which are suitable for the machine. Saw blades should never be
used.
Even if the machine is used as intended, certain residual risk factors cannot be completely
eliminated. For reasons of design and the construction of the machine, the following
eventualities are possible:
• Contact with the diamond cutting disc where it is not covered.
• Contact with the diamond cutting disc while it is turning.
• Defective diamond tips flying off the cutting disc.
• Workpieces or parts of workpieces kicking back.
• Damage to hearing if the ear-muffs specified are not used.
Do not lose these safety Instructions.
CAUTION:
The cutting disc runs on after the machine is switched off! Never apply
side pressure to the diamond cutting wheel in order to bring it to a halt.
CAUTION:
The diamond cutting disc must be cooled with water at all times.
