5
Congratulations on purchasing a Full Boar Brick &
Masonry Saw.
The Full Boar Brick & Masonry Saw FBBMS-20350 is
designed for cutting bricks, pavers, stone, terracotta and
various building blocks. It should never be used for the
cutting of wood, metal or tile.
INTRODUCTION
WARNING!
When using mains-powered equipment, basic safety precautions,
including the following, should always be followed to reduce risk of fire, electric
shock, personal injury and material damage.
SAFETY INSTRUCTIONS
ELECTRICAL SAFETY
Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for future reference.
The electric motor has been designed for 230V and 240V only. Always check that the power
supply corresponds to the voltage on the rating plate.
Note:
The supply of 230V and 240V on Full Boar tools are interchangeable for Australia and
New Zealand.
Note:
The power outlet used for the brick & masonry saw must be protected by a 30mA
residual current device or earth leakage circuit breaker.
The supply cored assessed as type Y attached by using AS/NZS 60335.1.
If the supply cord is damaged, it must be replaced by an electrician or a power tool repairer
in order to avoid a hazard.
Using an Extension Lead
Always use an approved heavy duty extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing. Replace the
extension lead if damaged or defective. When using an extension lead on a reel, always
unwind the lead completely. Use of an extension lead not suitable for the power input of the
tool or which is damaged or defective may result in a risk of fire and electric shock.
WARNING!
Always use the tool with a residual current device (rated
30mA or less) at all times.
