17
OPERATION (cont.)
Removing fasteners from the magazine
1.
Pull back the sleeve on female quick connector to disconnect the tool from the
air supply.
2.
Grip the handle firmly with one hand and with the other hand press down on
the magazine latch to release the strip of nails.
3.
Tilt the tool up and remove the strip of fasteners from the magazine.
4.
Push the magazine latch forward until it is locked.
WARNING!
Disconnect the tool from the air supply before removing
fasteners. Failure to do so could result in serious personal injury.
Drive depth adjustment
The driving depth of the fastener may be adjusted. The depth of drive is made by
rotating the Depth adjustment selector (fig. 9).
- If the fastener is driven into the work piece at an excessive depth (the fastener
head is driven below the work surface, the depth adjustment selector should be
rotated clockwise.
- If the fastener is protruding (the head is not
flush with the surface), the depth adjustment
selector should be rotated anti-clockwise.
WARNING!
Keep the tool pointed in a safe direction. Disconnect the tool
from the air supply and remove all fasteners. Failure to do so could result
in serious personal injury.
Fig. 9
