Page 5 of 7
2017-735-5 Rev A
SPECIFICATIONS
MECHANICAL DATA
100%-1%,0%
E477042
LiFePO4
FHSAC1-UNV-40L
TEST SWITCH OPERATIONS:
1. EM Test: Press and hold test button (>1s)to enter EM mode for testing in normal AC powered .
2. Manual Self-Diagnostic(When Self-Diagnostic Enabled - Dip Switch 1 set to the ON position): After charging twelve
(12) hours or battery fully charged, quickly press the test button three(3) times within three(3) seconds to force the
controller to enter a Self-Diagnostic cycle. To quit the self-diagnostic cycle after engaged press and hold the test button
for ten(10) seconds.
TEST SWITCH INDICATOR STATUS:
Programming:
This driver can be programmed using the TPSB-100(E). Programming features include the following:
*
Output Current :250-1400mA
*
Dimming Curve
*
LED NTC Thermal Protection
LED Indicators Status
EM Driver Status/Mode
•
Solid Green
Sys tem OK/AC OK(Self-diagnos tic Enabled or D is abled).
•
Slow Flas hing R ed, 4s on/1s off
Battery not detected, check battery s w itch or connection.
•
Flas hing R ed, 1s on/1s off
Battery Failure, replace battery.
•
Flas hing Green, 1s on/1s off
Self-D iagnos tic tes t underw ay.
•
Fas t Flas hing R ed, 0.1s on/0.1s off
Abnorm al driver perform ance, replace driver.
•
Very Slow Flas hing R ed, 4s on/4s off
Over tem perature.
•
N one. Both LED s OFF
N orm al w orking in EM m ode.
•
Green/R ed alternative flas hing, 1s green/1s red.
N o load or output over voltage protection triggered.
Fulham extends a limited warranty to the original purchaser or first user for a period of 5 years from the date of manufacture when properly installed
and operated under normal conditions of use. For complete terms and conditions, please refer to the Warranty Center at www.fulham.com.
Specifications subject to change without notice.
