IMPORTANT!
1.
Rated for temperature range of 10°C-40°C (50°F-104°F) and suitable for use in an application that is
designated as a damp location area as defined by NEC Article 100, Location, Damp.
2.
Used indoors.
tampering by unauthorized personnel.
4.
Do not mount near gas or electric heaters.
5.
The use of accessory equipment is not recommended by the manufacturer and may cause an unsafe condition.
6.
Do not use this equipment for anything other than its intended use.
7.
Servicing of this equipment should be performed by qualified personnel.
Page 1 of 2
20
-
Rev B
14 488
Fulham Co. Inc.: 12705 South Van Ness Ave., Hawthorne, CA 90250 Tel.: 1-323-779-2980 Fax.: 1-323-754-9060.
Specifications subject to change without notice.
[email protected] www.fulham.com
3.
Equipment should be mounted in locations and at heights where it will not be subject to
SAVE THESE INSTRUCTIONS
1. Open the Base plate and lead out a wire after getting through the hole on the Base plate.
Fix the Base plate on J-Box with screws.
2. Then connect to AC power (Fig.A).
3. Connect to the battery with connectors (Fig.B).
4. Install the housing to Base plate, turn on the AC power and press the "TEST" button check light (Fig.C).
INSTALLATION (J-BOX Mounting)
8.
Disconnect AC power before servicing.
INSTALLATION (CONDUIT)
1. Secure Base Plate to wall surface. Route wires through hole in conduit flange and make conduit
connection. Use flexible conduit only.
2. Connect battery only after continuous AC power is being supplied to the unit (Fig. B).
3. Align snaps and push housing directly onto the Base Plate (Fig. C). Apply continuous AC power
and press "TEST" button to check light.
GENERAL INSTALLATION
GUIDELINES FOR EMERGENCY
LIGHTING FIXTURE
(FHEM12 Series)
When using electrical equipment, basic safety precautions should always be followed including
the following:
IMPORTANT SAFEGUARDS
PLEASE READ CAREFULLY AND FOLLOW ALL INSTRUCTIONS FOR YOU SAFETY
Fig. A
Fig. B
Fig. C
•The battery in this unit may not be fully charged. After electricity is connected to the unit, let battery
charge up for at least 24 hours. Then the normal operation of ths unit should take effect.
To check press the “TEST” button and the lights on the unit should turn ON.
• In order to maintain proper operation and warranty coverage, the battery must be recharged once
per year prior to installation
WARNING:
Unused wires must be
capped using enclosed
FLEXIBLE
CONDUIT
ONLY
wire nuts.
