Fulgor Milano FWC 8200 U TC, Инструкция по установке и эксплуатации

Страница: 23 / 96

EN
3
INSTALLATION INSTRUCTIONS FOR
BUILT IN WINE CELLARS: (UNDERBENCH
OR IN COLUMN) FRONT VENTING WINE
CELLARS ONLY.
1. “Built in” wine cellars are front venting but are not
designed to be fully integrated behind a joinery door.
2. Please follow the installation diagram when installing
built-in wine cellars. No less than the minimum installation
dimension, or it will affect the venting of cellar.
3. Built-in wine cellars draw air from right of ventilation
frame and expel through left of ventilation frame under
the front door.
4. “Built in” wine cellars have a power switch located on
the control panel so power point location is not critical.
5. The wine cellar requires a standard 240 volt/10 amp
power point. (Or according to different countries
specifications).
6. The power cord is 2.0m in length and is fixed on the
right side at the back when looking from front of cabinet.
7. As with most appliances of today, the wine cellar has
sensitive electronic components which are susceptible to
damage through lightning and electricity supply faults.
It is therefore advised to use a power surge protector to
avoid problems of this nature.
8. Air vent on door must be provided for built-in wine
cellars when a wood door installed.
In Hot climate zone, an air vent or grid, with a minimum
ventilation size of 200mm x 40mm MUST be cut out at the
rear top of the back partitioning or at the top of either side
of the partitioning, allowing cool fresh air full access to flow
into the 30mm gap located at the rear of the cabinet.
This air vent or grid must not be opened on the same side
as other appliances such as ovens or an area that is sealed
and without access to fresh cool air. Failing to comply with
the above specifications could result in WARRANTY void.
INSTALLATION DRAWINGS FOR BUILT
IN WINE CELLARS: (UNDERBENCH OR
IN COLUMN) FRONT VENTING WINE
CELLARS ONLY.
Note: The appliance must be positioned so that
the plug is accessible after installed.