Fulgor Milano F7IT S1 Series, Инструкция по использованию и уходу

Страница: 11 / 56

EN
7
4 - Induction Cooktop Operation
Before using the cooktop for the first time
• All products are wiped clean with solvents at the actory to
remove any visible signs of dirt, oil, and grease which may
have remained from the manufacturing process.
• If present, remove all packing and literature from the cooktop
surface.
• Clean your glass top before the first time you use it. A
thorough cleaning with a glass top cleaner is recommended.
It only takes a minute and puts a clean, shiny coating on the
glass top before its initial use.
• There may be a slight odour during the first several uses: this
is normal and will disappear.
• Optimum cooking result depends on the proper cookware
being selected and used.
• The cooking surface will hold the heat and remain hot over
20 minutes after the elements have been turned off.
• The glass ceramic cooking surface is a durable material
resistant to impact but not unbreakable if a pan or other
object is dropped on it.
• Do nor allow pans to boil dry. This can damage the pan,
element and /or cooktop.
• Do not slide cookware across cooking surface it may scratch
the glass
4 burner cooktops with right and lift side (2) induction
generators.
5 burner cooktops with right and lift center (3) induction
generators.
Power Sharing
Four burner cooktops
are divided into two separate heating
zones.
Five burner cooktops are divided into 3 zones.
One generator controls 2 elements, or two cooking zones
within a heating section share the power of one generator.
Power Sharing is activated when both elements in the same
cooking zone are activated and one element is set for Boost
(P). The element that is not set for Boost will change to a lower
power level. This is called Power Sharing.
Cookware “noise”
When using adjacent elements that are set at certain power
level setting, magnetic fields may interact and produce a low
whistle or intermitted “hum”. Pens that completely cover the
elements ring will produce less noise. A low “humming” noise
is normal particularly on high settings. These noises can be
reduced or eliminated by lowering or raising the power level
settings of one or both of elements.