Fulbat FULLOAD F12, Руководство по эксплуатации

Страница: 4 / 16

TECHNICAL SPECIFICATIONS:
Output 12A @ 12V
Input Voltage 220-240Vac 1.8A (175W)
Input Frequency 50/60Hz
Charge Voltage Gel - 14.1V
AGM & WET - 14.4V
Calcium - 14.7V
Equalizing Voltage Gel - 14.3V
AGM & WET - 14.6V
Calcium - 15.5V
Float Voltage 13.6V
Start Voltage 3V
Operating
Temperature -15 to 50° C
Storage Temperature -25 to 85°C
Operating Humidity
90% RH Max.
Size (L x W x H) 214mm x 103mm x 55mm
Weight 1.1 kg
Approvals CE
CHARGING INSTRUCTIONS:
STEP 1 - Pre charge check & electrolyte level check

Check the Battery Electrolyte levels (Not required on sealed & maintenance free batteries). If necessary,
remove the vent caps and add distilled water so the levels are halfway between the upper and lower fill
lines.

Check the battery voltage, type and Ah capacity to ensure the charger is compatible and to determine which
Battery Type and Charge Rate settings you will use.

Ensure the battery is in a well-ventilated area and the charger should be as far away from the battery as the
cables permit.
STEP 2 - Connecting the battery charger to your battery
If the Battery is out of the vehicle:
- Connect the Red (+) Crocodile clip or optional ring terminal to the (+)
battery terminal.
- Connect the Black (-) Crocodile clip or optional ring terminal to the (-)
battery terminal
If the battery is still in the vehicle , determine if the vehicle is positively or negatively earthed.
If Negatively Earthed (Most Common) – FIRST Connect the Red (+)
Crocodile clip or optional ring terminal lead to the (+) battery terminal
and then connect the Black (-) Crocodile clip or optional ring terminal
lead to the vehicle’s chassis. DO NOT connect the Black (-) lead to the
carburetor or fuel lines.
If Positively Earthed – FIRST Connect the Black (-) Crocodile clip or
optional ring terminal lead to the (-) battery terminal and then connect
the Red (+) Crocodile clip or optional ring terminal lead to the vehicle’s
chassis. DO NOT connect the Red (+) lead to the carburetor or fuel
lines.
STEP 3 - Connect the battery charger to Mains Power (230Vac)
The charger will automatically start when AC power is connected and switched on.
IMPORTANT: Please make sure the correct Battery Type and your desired Charge Rate is selected to suit your
battery by pressing the Select Buttons within the first 5 minutes of charging. For Example do not charge a Gel