charge capacity in reached in 2hrs. (nb. You cannot “overcharge” the battery.)
The laser cannot be operated without a fitted battery but can be operated
whilst the instrument is being charged.
Important note:
We would recommend that a spare Li-ion battery is kept in the carry case as
a back-up, in instances where mains operated equipment is prohibited on-
site.
Positioning the Laser:
Mount the FLE-444G on a generally level, firm surface or a 5/8” threaded
laser accessory eg. a Tripod or a Floor to Ceiling Pillar. You may need to use
the supplied post adapter. To operate correctly, this surface must be within
+/-4 deg of true horizontal.
If the laser alarms (ie. the green beams flash on & off every second), then it
is outside its levelling range.
If possible, re-adjust the laser into range via its adjusting feet or the tripod
legs.
Principle of Operation:
This instrument has a fully automatic, servo motor system to set true level.
IF THE FLE-444G EMITS CONTINUOUS GREEN LASER LINES, THEN
THEY WILL ALL BE TRUE LEVEL & PLUMB.*
Also see Manual setting
details below.
This laser can be used indoors or outdoors, where it is waterproof to IP33.
Controls:
The laser is powered-up via the ON/OFF button on the keypad. Note the red
LED. Press again to switch OFF.
On initial power-up, the front facing horizontal laser beam will switch on.
A flashing green LED denotes "its finding level" which then changes to a
steady green LED to confirm TRUE LEVEL. Press the "H" button to give 4
beam 360 deg coverage & press again to switch off.
A second button marked "V1" is used to switch two vertical laser plumb lines
ON or OFF and the third button marked "V2", to switch the other two vertical
lines.
Also note, the red down dot beneath the legs. This gives true electronic
plumb between the ceiling cross & the down dot.
Manual Over-ride:
2
