Fujitsu TeamPoS 3600 Series, Инструкция по установке и обслуживанию

Страница: 116 / 165

Team PoS 3600 Series
Troubleshooting
D900000338 Issue 3 8-2
8.3 Display Issues
Display/LCD shows correctly during Power On Self Test (POST), but fails when the Operating System (OS) starts
Caution: Before replacing any boards, unplug the power cable and make sure the
motherboard standby power LED light is out.
Display/LCD shows
correctly during Power On
Self Test (POST), but fails
when the Operating
System (OS) starts
Does the display show properly if
terminal is booted up in “Safe Mode” (F8
pressed during POST) (Windows Only)
Display drivers wrong or not installed
properly – Go to Device Mgr and update
all display adapters. See PSB-07-002
on display mode issues. See
ftp.ftxs.fujitsu.com/pos/
possustaining/Retail/
TeamPoS3600XL/SPG. If failure still
occurs O/S could be corrupted – reload.
Does the display go blank at
different times when the OS is
running?
Yes
No
Does the display work
properly if terminal is booted
up from another device? (ex.
USB key, CD, floppy)
Operating System could be corrupted
on hard drive or hard drive is bad.
Reseat hard disk and reboot. If failure
still occurs reload software or remove
and replace HDD.
Go into the BIOS by hitting
Delete during POST, and “Load
Optimized Defaults”. Does the
display work properly?
No
Yes
No
End
Does the display
work properly after
replacing the LCD?
End
Does the display work
properly after replacing
the motherboard
End
Change the
controller
No
No No
Yes
Yes
Yes
Yes