Fujitsu SPARC M10-4, Руководство по обслуживанию, Страница: 66 / 514

XSCF>
showhardconf
Table 4-2 Commands for checking the software configuration
Command Description
pkg(1) (Oracle Solaris 11)
showrev(1M) (Oracle Solaris 10)
Displays Oracle Solaris correction information
and version.
ldm(1M) Displays logical domain configuration information.
system, record the system configuration and the states of the components before
starting maintenance. Then, confirm that the system configuration is the same after
maintenance as it was before.
4.2.1 Confirming the hardware configuration
Execute the showhardconf command to confirm the configuration and status of the
components mounted in the chassis. Before performing any maintenance work, check
and record the hardware configuration of the chassis.
1.
Log in to the XSCF shell.
2.
Execute the showhardconf command to confirm the hardware configuration
information.
The following information is displayed:
■
Current configuration and status
■
Number of mounted Field Replaceable Units (FRUs)
■
Status of the unit in which a physical partition error or degradation occurred
■
Information on the PCI expansion unit
■
Name properties of the PCI Express (PCIe) card
4.2.2 Confirming the software and firmware
configurations
The software and firmware configurations and versions affect the operation of the
system. To change the configuration or investigate a problem, check the latest state
and check for any problems in the software.
Confirming the software configuration
Use Oracle Solaris commands to check the software configuration.
If you are logged in to the XSCF console, switch to the control domain console by
executing the console command beforehand.
Table 4-2 lists the commands used for checking the software configuration.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
February 2014 42