Fujitsu PRIMERGY TX1330 M4, Руководство по эксплуатации

Страница: 79 / 110

TX1330 M4
Operating Manual 79
6 Operation
V
CAUTION!
Follow the safety instructions in chapter "Important information" on
page 43 .
6.1 Switching the server on and off
V
CAUTION!
●
If nothing appears on the screen but flickering stripes after switching
on the server, switch off the server immediately (see chapter
"Troubleshooting and tips" on page 93 ).
●
The On/Off button does not disconnect the server from the mains. To
completely disconnect it from the mains, remove the power cords
from the PSUs.
●
Do not move, strike, or shake the server when it is switched on. This
can damage the HDD/SSD in the server and cause data loss.
●
Switch the server on when the temperature is in the specified
temperature range. For more information on the operating
environment, see
"Ambient conditions" on page 105 . When operating
the server out of the specified temperature range, the server may
operate improperly and data loss may occur. Furthermore, Fujitsu
cannot be held responsible for any related damage, malfunction, or
loss of data, etc.
●
Ensure that you wait for 10 seconds or more after power off before
switching on the server again.
●
After connecting all power cords, wait at least 10 seconds before
pressing the On/Off button.
Switching the server on
The AC connected indicator lights up green (standby mode) when the server is
connected to the mains.
I
It will take about 60 seconds until the server can be switched on.