Fujitsu PRIMERGY CX400 M4, Руководство по эксплуатации

Страница: 62 / 84

62 Operating Manual
CX400 M4
Starting up
V
CAUTION!
●
It nothing appears on the screen but flickering stripes after switching
on the server node, switch the server node off immediately (see
chapter
"Technical data" on page 77 ).
●
The On/Off button does not disconnect the server node from the
mains voltage. To completely disconnect it from the mains voltage,
remove the power plug(s) from the socket(s).
●
Do not move, strike, or shake the multi-node server system when it is
turned on. This can damage the hard disk in the server node and
cause data loss.
●
Turn the multi-node server system on when the temperature is in its
operating environment range (5°C ~ 35°C). For details on the
operating environment, refer to "Safety Precautions". When
operating the device outside of this operating environment, the multi-
node server system may operate improperly, damage data etc.
Furthermore, Fujitsu cannot be held responsible for any related
damage, malfunction, or loss of data, etc.
●
Be sure to wait for 10 seconds or more after shutdown before turning
the server node on.
●
After connecting the power cord, press the On/Off button after it
passes for more than 10 seconds.
Switching the server node on
The AC connected indicator lights up green (standby mode) when the server is
connected to the mains.
I
It will take about 60 seconds until the server can be switched on.
Starting up
For Japan, see "
はじめにお読みください
".
Ê
Press the On/Off button.
Ê
Insert ServerView Suite DVD in the DVD drive.
Ê
Follow the on-screen instructions (for more information, see the Operating
Manual of the installed server node).