Fujitsu LTO-5, Руководство пользователя

Страница: 11 / 34

LTO-5 Half-Height SAS Tape Drives
11
2 Verify installation
Once you have installed the drive hardware, check that drivers have been
installed correctly and you have the correct version of backup software, and
verify that the tape drive is functioning properly before you store your valuable
data.
1. Switch on the server.
2. The tape drive will run its hardware self-test, which takes about 5 seconds.
If self-test passes, the green Ready LED flashes and then shows steady
green. If the test fails, the Drive and Tape LEDs flash, while the Ready and
Clean LEDs are off. This continues until the drive is reset. See
"Understanding LED sequences" on page 27 for more information about
front panel LEDs.
● If you installed drivers before connecting the tape drive (Windows
only)
The tape drive should be detected automatically and the correct drivers
used.
● Installing drivers after connecting the tape drive (Windows only)
If you have not already installed drivers, install the driver according to the
supplied documentation
in the driver's folder.
●
Installing drivers (other operating systems)
Drivers are included with the operating system and should be loaded
automatically.
NOTE:
Certain backup applications require you to use their own Tape driver.
3. Verify that the tape drive installation was successful.
4. For all operating systems ensure that you have downloaded any upgrades
necessary for your backup application.