MB2147 – Installation Guide
Chapter 4 Troubleshooting
MCU-AN-390070-E-V29
- 20 -
© Fujitsu Microelectronics Europe GmbH
4 Troubleshooting
TROUBLE DURING INSTALLATION
4.1 Emulator Software does not work in debugging mode
Note, that the Emulator Software will not work if the Emulator is not powered on, not
connected to a Target Board, not connected properly to a PC or if no Evaluation MCU is in
the socket.
The Target Board must provide power logic signals to all MCU pins.
4.2 Wrong COM-Port in Softune Workbench
The basic setting after installation for the RS232-PC-COM-Port is COM1. If you want to use
your COM2-Port then click with the right mouse button on the entry MB2147-01_COM1.sup
in the project window. Then a small popup window is displayed. Choose
change
.
Now a Setup Wizard starts. Let all entries in their default states, until the following window
occurs:
In this window, you can choose the COM2 port.
Click
Next>
and finally
Finish
.
4.3 Emulator
MB2147-01
Menu
Settings
Use the following settings for the Emulator 2147-01 in case of trouble:
Menu
1.) LAN
1.) IP Address:
(defined by System Administrator)
2.) Subnet Mask:
(defined by System Administrator)
3.) MAC Address:
(defined by System Administrator)
4.) Port Address:
(defined by System Administrator)
