MB2147 – Installation Guide
Chapter 2 Setting up the Emulation System
MCU-AN-390070-E-V29
- 14 -
© Fujitsu Microelectronics Europe GmbH
2.1.8.2 Procedure for Adapter Board MB2147-10
The procedure is the same like for the
MB2147-20. But pay attention, that Pin
1 mark is turned by 90° clockwise to
the MB2147-20 Adapter Board’s mark.
2.1.9 Connect the Probe Cable to the Adapter Board
Connect a Probe Cable to the Adapter
Board. For e. g. MB90V390 use the
LQFP120 NQPACK PROBE cable
(MB2132-469).
The cable has to insert in the PROBE CN
A2 (CN1) and PROBE CN A1 (CN2)
connectors on the Adapter Board.
2.1.10 Connect the Emulator System with the Starter Kit
Connect the Probe Cable to a Starter Kit
(e. g. Flash-Can-120-390).
Insert the cable properly into the MCU
socket on the Starter Kit Board. Note, that
it fits only in the correct position: Three
edges of the socket are round and one is
flat. In
addition both
the probe
socket and
the Board
have small triangles which point to Pin 1.
After inserting, use a small cross tip screwdriver to fix the four screws of the probe cable.
Note: The procedure is similar to a 0.5
O
m target system
