Note
-
If an invalid option is specified, its corresponding error message is output in the install log file and the process exits. No error
message is output in the command prompt or screen.
-
Do not execute multiplexly the command for silent installation. If it is multiplexly executed, the command executed after
that terminates abnormally. At this time, an install log file is not created.
-
During an update, it is not possible to specify an installation parameter file for the command. In the case that a file has been
specified, the command terminates in an error.
5.
On completion of installation, a command prompt is displayed.
Eject the DVD-ROM.
10.3.2.3.2 Confirming Results of Upgrade with Silent Installation (Primary Node)
Check the return value from the silent installation command. If necessary, check the install log file. However, if the return value from
the silent installation command is 3 or 9, an install log file is not created. For details, refer to "Return Values for Silent Installation (for
AdvancedCopy Manager's Agent)" in the
ETERNUS SF Installation and Setup Guide
.
The installation result can be viewed in the install log file, too.
Open the install log file to see "ResultCode" in the ResponseResult section. In "ResultCode" is written the return value from the silent
installation command.
Point
If the Upgrade Installation has ended in an error, refer to "
11.3.5 In Case of Problem During Upgrade of AdvancedCopy Manager's Agent
" and return the system to a normal state.
10.3.2.4 Tasks to Be Performed After Upgrade (Primary Node)
When the upgrade has been completed, the tasks below need to be performed.
If multiple Managed Server transactions exist, use this procedure in each primary node for Managed Server transaction.
Edit the following environment setting files for Managed Server transaction on the shared disk for shared data:
-
<
Drive of shared disk for shared data of Managed Server transaction
>:\etc\opt\swstorage\clsetup.ini
-
<
Drive of shared disk for shared data of Managed Server transaction
>:\etc\opt\swstorage\etc\swstg.ini
Change the version information within each file, as follows.
Upgrade Patterns
Descriptive Contents of Version Information
Before
After
Version 16.0 to 16.6
Version=V16.0
Version=V16.6
Version 16.1 to 16.6
Version=V16.1
Version 16.2 to 16.6
Version=V16.2
Version 16.3 to 16.6
Version=V16.3
Version 16.4 to 16.6
Version=V16.4
Version 16.5 to 16.6
Version=V16.5
Note
Do not change anything other than the version information.
- 229 -