Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set fc-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
197
loop
Loop connection (default)
fabric
Fabric connection
-rate
Optional. This parameter specifies the FC transfer rate. If omitted, the existing setting is not
changed.
auto Auto negotiation
1g
1Gbit/s (Not supported)
2g
2Gbit/s
4g
4Gbit/s
8g
8Gbit/s
16g
16Gbit/s
Specify "auto", "2g", "4g", "8g", or "16g" for the transfer rate. Note that "1g" is not supported.
-loop-id-assign
Optional. This parameter specifies how to assign the loop ID. It is only applicable when
"-connect loop" is specified. If omitted, the existing setting is not changed.
auto-ascending
It automatically assigns ascending order.
auto-descending
It automatically assigns descending order.
manual
It assigns manually.
-loop-id
Optional. This parameter specifies the loop ID (a hexadecimal number). This is only applicable
when "-loop-id-assign manual" is specified. The range of values is between 0x00 and 0x7d (a
hexadecimal number). If omitted, the existing setting is not changed.
-frame-size Optional. This parameter specifies the FC frame size. If omitted, the existing setting is not
changed. If the RA mode or Initiator mode is being set for the specified ports, this parameter
cannot be specified.
512
512 byte.
1024
1024 byte.
2048
2048 byte.
-host-response-number
or
-host-response-name
Optional. This parameter specifies a host response identifier. Only one host response identifier
can be specified at the same time. If omitted, the existing setting is not changed. If the RA
mode or Initiator mode is being set for the specified ports, this parameter cannot be specified.
For details, refer to
"1.2.12 Host Response Syntax" (page 24)
.
Содержание Eternus DX410 S2
Страница 2: ...This page is intentionally left blank ...
Страница 756: ......