En-6
Load Batteries (R03/LR03 × 2)
1
Press and slide the battery compartment lid on the
reverse side to open it.
Slide in the direction of the arrow while pressing the mark.
2
Insert
batteries.
Be sure to align the battery polarities (
) correctly.
3
Close the battery compartment lid.
Set the Current Time
1
Press the CLOCK ADJUST button.
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET (
/
) buttons to adjust the
clock to the current time.
button:
Press to advance the time.
button:
Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
1 minute increments; hold the buttons depressed to change the time quickly
in 10 minute increments.)
3
Press the CLOCK ADJUST button again.
This completes the time setting and starts the clock.
To Use the Remote controller
●
The Remote controller must be pointed at signal receiver to operate correctly.
●
Operating range: About 7 meters.
●
When a signal is properly received by the air conditioner, a beeping sound will be
heard.
●
If no beep is heard, press the Remote controller button again.
Remote controller Holder
1
Mount the
Holder.
Screws
2
Set the Remote con-
troller
Insert
Press in
3
To remove the Remote con-
troller (when use at hand).
Slide up
Pull out
PREPARATION
WARNING
●
Take care to prevent infants and young
children from accidentally swallowing the
batteries.
CAUTION
●
To prevent malfunction or damage of the
remote controller:
- Place remote controller at where will not
be exposed to direct sunlight or excessive
heat.
- Remove batteries if the product is not
going to be used for an extended period.
- Exhausted batteries must be removed
immediately, and be disposed according
to the local laws and regulations of your
region.
●
If leaking battery
fl
uid comes in contact with
your skin, eyes, or mouth, immediately rinse
with plenty of clean water, and consult your
physician.
●
Obstacles such as a curtain or wall between
the remote controller and the indoor
unit may affect the appropriate signal
transmission.
●
Do not apply strong shocks to the remote
controller.
●
Do not pour water on the remote controller.
●
Do not attempt to recharge dry batteries.
●
Do not use dry batteries that has been
recharged.
Use speci
fi
ed type of batteries only.
Do not mix different types or new and
used batteries together.
Batteries can be used about 1 year in
ordinary use. If the remote control
range noticeably shortens, replace the
batteries, and press “RESET” button
with the tip of a ball point pen or other
small object.
OM 01_9374379712-02 EN.indd 6
OM 01_9374379712-02 EN.indd 6
1/22/2559 BE 21:37
1/22/2559 BE 21:37
