En-5
NAME OF PARTS
Remote controller
Display panel
1
MODE button
2
10°C HEAT button
3
SET TEMP. button (
/
)
4
ECONOMY button
5
SLEEP button
6
FAN button
7
START/STOP button
8
SET button
9
SWING button
!
TIMER MODE button
"
TIMER SET (
/
) button
#
CLOCK ADJUST button
$
RESET button
%
TEST RUN button
●
This button is used when installing the
conditioner, and should not be used under
normal conditions, as it will cause the air
conditioner’s thermostat function to operate
incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test operation
mode, and the indoor unit’s OPERATION in-
dicator lamp and TIMER indicator lamp will
begin to
fl
ash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
&
Signal transmitter
(
Temperature SET indicator
)
Operating mode indicator
~
SLEEP indicator
+
Transmit indicator
,
Fan speed indicator
-
SWING indicator
.
Timer mode indicator
/
Clock indicator
Some indoor units may not be equipped with the functions
corresponding to all of the buttons on this remote control-
ler. The indoor unit will beep and the OPERATION, TIMER
and ECONOMY lamp
fl
ash when a remote controller but-
ton is pressed if the function is not available.
Display panel
To facilitate explanation, the accompanying illustration has
been drawn to show all possible indicators; in actual oper-
ation, however, the display will only show those indicators
appropriate to the current operation.
OM 01_9374379712-02 EN.indd 5
OM 01_9374379712-02 EN.indd 5
1/22/2559 BE 21:37
1/22/2559 BE 21:37
