En-5
Display panel
To facilitate explanation, the accompanying illustration has
been drawn to show all possible indicators; in actual oper-
ation, however, the display will only show those indicators
appropriate to the current operation.
1
MODE button
2
10 °C HEAT button
3
SET TEMP. button (
/
)
4
ECONOMY button
5
SLEEP button
6
FAN button
7
START/STOP button
8
SET button (Vertical)
9
SET button (Horizontal)
0
SWING button
A
TIMER MODE button
B
TIMER SET (
/
) button
C
CLOCK ADJUST button
D
RESET button
E
TEST RUN button
●
This button is used when installing the
conditioner, and should not be used under
normal conditions, as it will cause the air
conditioner’s thermostat function to operate
incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test run mode,
and the indoor unit’s OPERATION indicator
lamp and TIMER indicator lamp will begin to
fl
ash simultaneously.
●
To stop the test run, press the START/STOP
button to stop the air conditioner.
F
Signal transmitter
G
Temperature SET indicator
H
Operating mode indicator
I
SLEEP indicator
J
Transmit indicator
K
Fan speed indicator
L
SWING indicator
M
T imer mode indicator
N
Clock indicator
Some indoor units may not be equipped with the functions
corresponding to all of the buttons on this remote control-
ler. The indoor unit will beep and the OPERATION, TIMER
and ECONOMY lamp
fl
ash when a remote controller but-
ton is pressed if the function is not available.
Remote controller
Display panel
9374379729_OM.indb 5
9374379729_OM.indb 5
24/06/2013 09:41:18
24/06/2013 09:41:18
