Fujioh FH-GS6020 SVGL, Руководство по эксплуатации и установке

Страница: 20 / 24

Inlet g as c onnection
1 9
Important:
■ The appliance should be installed, regulated and adapted to function with other
types of gas by a QUALIFIED INSTALLATION TECHNICIAN.
■ The appliance is fitted with specified gas type as shown in the specification
nameplate and cannot be used or converted to any other type of gas.
I nstallation :
■ The appliance is predisposed and adjusted to operate with the gas indicated
on the specifications nameplate located at the bottom of the appliance.
Please ensure that the intended gas type used corresponds with that
specified on the nameplate.
Gas connection for gas hob:
■ The appliance should be connected to the gas-supply by licensed installer.
During installation of this appliance , it is essential to fit an approved gas tap
to isolate the supply from the appliance for the convenience of any subsequent
removal or servicing. Connection of the appliance to the gas mains or liquid
gas must be carried out according to the presc r ibed regulation in force, and
only after it is ascertained that it is adaptable to the type of gas to be used.
In the case of connection to liquid gas, by tank, use pressure regulators
that conform to the regulation in force. Connection to the gas course must
be done in such a way that not to create any stress points any part of the
appliance.
IMPORTANT: For safety, for the correct regulation of gas use and long life of
the appliance, ensure that the gas pressure conforms to the indications given
in table 1 “ Nozzle and burner characteristics" .
Installation instructions for fixing gas cooker elbow joint :
The gasket depicted above is to prevent gas leakage. After installation, turn on the ■
gasket
intake pipe of the
whole machine
elbow joint
gas source
connector
gas supply and use soap solution (never use naked flame) to check for gas leakage.
When NG/TG is installed, the connection installation is shown in the figure: