Air Suction Feeder
27
Postcard Setting
Attach Postcard Kit for Air Suction Feeder to the Paper Tray to load paper with the width of 100
to 181 mm.
1.
Pull out the Paper Tray toward you until it stops.
2.
Remove any paper remaining in the Paper Tray.
3.
Remove the shutters.
(1)
Fold the shutters.
(2)
Hold the shutters up and remove them.
4.
Insert the guide A into the slit on the interior side
(
1
) and the slit on the bottom (
2
), and then tight-
en the screw of the guide to fix (
3
).
5.
Insert the guide B into the slit on your side (
1
) and
the slit on the bottom (
2
), and then tighten the
screw of the guide to fix (
3
).
Important
If the screw is not tighten well, it may hit on the transport device to
result in break.
6.
Load about 100 to 500 sheets of paper with the
printed side facing up, and align the paper edges in
the direction of the arrow (
1
).
Note
• Be sure to set them in short edge feed.
• The right side short edge of the set postcard will be the front edge.
7.
Pinch the long-side paper guide grip and adjust to
the correct paper size (
2
).
1
2
1
3
1
2
3
1
2
1
2