FujiFilm DR-ID 1200PB, Руководство по эксплуатации

Страница: 17 / 28

3-1
Basic Operation
3
DR-ID 1200PB Operation Manual
897N120972A
Chapter 3
Basic Operation
3.1 Preparing the Flat Panel Sensor
This section describes how to prepare the fl at panel sensor.
3.1.1 Number of the Connectable Flat Panel Sensors
Only one fl at panel sensor can be connected to one power box in wired communication mode. Up to
three power boxes can be used for one system.
The types of connectable fl at panel sensors are DR-ID 1201SE, DR-ID 1202SE, DR-ID 1211SE,
DR-ID 1212SE and DR-ID 1213SE.
3.1.2 Connecting/Disconnecting the Flat Panel Sensor
Connector
When multiple fl at panel sensors are used, make sure that the READY lamp among the status lamps of the fl at
panel sensor to be used for an exposure is lit.
Connect/Disconnect the connector straight to the fl at panel sensor. If connected/disconnected at an angle, the
connector may be damaged.
Before connecting the connector to the fl at panel sensor, make sure that the power box is turned on. If the
connector is connected to the fl at panel sensor with the power box turned off, the fl at panel sensor turns off.
1
Disconnect the connector.
Press the latches on both sides of the connector.
2
Connect the connector.
Press the connector into the insertion section.
Make sure that the latches on both sides are
properly engaged when connecting the connector.
If the connector is inserted incompletely, the power
may turn off.