Fuji Electric MONITOUCH X1 Series, Технические характеристики

Страница: 42 / 180

3.1 Installation
3-1
1
2
3
4
5
6
7
8
9
10
3.1 Installation
3.1.1 Mounting Method
1. Place the X1 series unit on a flat surface with the display screen facing down and insert the provided waterproof gasket into the
groove around the unit.
2. Fit the fall prevention fixtures on the bottom side of the X1 series unit on the bottom edge of the cut-out hole in the mounting panel
(maximum thickness of 4.0 mm).
* The unit can be mounted in the upright orientation only.
3. Looking from the front side, push up the upper right fall prevention fixture inward and then fit the X1 series unit in the panel cut-out
hole. Check that the fixture is fitted on the panel and the X1 series unit does not fall out forward.
4. Fit the provided fixtures into the mounting holes on the X1 series unit (8 positions: three each on the top and bottom and one each
on the left and right) and fix the unit in place with the tightening screws (tightening torque: 7.08 lbf-in (0.8 N·m)).
* Ground the mounting panel to prevent any buildup of static electricity.
The unit will not be waterproof if the waterproof gasket is not correctly inserted into the groove.
Failure to follow the above installation instructions and torque value may cause deformation, breakage, or malfunction of
the touch switch, which may result in damage to the machine or an accident. Also loose mounting may cause dropping,
short circuit, or malfunction.
Front View Rear View
Fall prevention fixtures
Front View Rear View
Push up the fall
prevention fixture
inward.
After fitting, check that the fall
prevention fixture is firmly
holding the mounting panel.
22.0
9.6
9.0
• Fixture dimensions
(unit: mm)