78
[Description]
• This parameter skips the parameter display by items.
• This parameter is used not to display the items that are
not used, or not to change the settings mistakenly.
to
to
Parameter display mask (Setting range: 0 to 255)
• “Parameter mask DSP” in “2-1 Parameter list” (pages 7
to 11) shows which parameter is skipped by setting
to
and
to
.
• Set the total value of the item codes that you want to skip.
[Setting example 1] Skipping “I” and “d”
Setting “4+8=12” according to the code table of dSP3
Press and hold the
SEL
key for five seconds.
will be displayed on the PV display.
Press the
key to display
.
Press the
SEL
key once.
The current setting ( ) flashes on the SV display.
Press the
or
keys to display .
Press the
SEL
key once. will stop flashing and will be registered for
. After that, the
parameters of and will be skipped, and will not be displayed.
If you want to display the operation status, press and hold the
SEL
key for two seconds.
Operating procedure
Display
1.
2.
3.
4.
5.
6.
Display parameter
.
Check a currently displayed value of
and reduce 64 from the value.
(Example: When a value of
is 127, 127-64=63).
Re-set the result of calculation obtained from Step 2 to
. (Example: Set 63 to
).
Operating procedure
1.
2.
3.
Display parameter
.
Check a currently displayed value of
and add 64 to the value.
(Example: When a value of
is 63, 63+64=127).
Re-set the result of calculation obtained from Step 2 to
. (Example: Set 127 to
).
Operating procedure
1.
2.
3.
[Setting example 3] Displaying the PV display (factory default)
Adding 64 to a value of parameter dP13
[Setting example 2] Extinguishing the PV display
Reducing 64 from parameter dP13
