MT5F22233b
© Fuji Electric Co., Ltd. All rights reserved.
2-4. Soldering the module to the printed circuit board after press-out
It is possible to reuse a module after press-out. Remove the PCB carefully. However, since the
press-fit terminals after press-out is deformed compared with the unmounted state, please solder the
contact part of the press-fit terminals and PCB when remounting.
The recommended conditions for soldering the module to the PCB are shown below.
Terminal temperature : 245
±
5ºC
Time : 5
±
0.5sec
The
recommended soldering temperature is defined as “terminal temperature”. This is different from
the preset temperature of the soldering equipment. Please set the temperature of the soldering
equipment according to the heat capacity of your PCB. Also, make sure that the resin temperature
below the module terminal during soldering does not exceed 260ºC.
10
