Fuerst FB42, Руководство оператора

Страница: 35 / 82

OPERATION
OPERATION
Operation Section 4-9
© 2004 Alamo Group Inc.
FB42 08/01
5. CONNECTING THE MOWER TO THE TRACTOR
Use extreme caution when connecting the mower to the tractor. The mower should be securely resting at
ground level or setting on blocks. Keep hands and feet from under the mower deck and clear of pinch points
between the tractor hitch arms and mower pins
.
Never stand or allow another person to stand between a running Tractor and the Mower
when attaching the Implement to the Tractor 3-point hitch. Always shut the Tractor off
completely and set the parking brake before attempting to connect the Mower pins to the
Tractor hitch.
DANGER!
1. Make sure the tractor is equipped with the correct
PTO shaft. Change shafts if needed.
2. Shorten or remove the tractor drawbar to avoid
interference when raising and lowering the mower.
3. Board the tractor and start the engine. Position
the tractor to the mower with the 3-point lift arms
positioned at the same height and to the outside
of the mower hitch pins. Note: Set the 3-point lift
control to “Position Control” so that the lift arms
maintain a constant height when attaching the
mower. See the tractor Operator’s Manual for
correct settings when attaching 3-point equipment.
4. Turn off the tractor engine and dismount.
5. One lift arm at a time, position the tractor lift arms
over the A-frame hitch pins. Insert linch pins to
retain lift arms to the mower.
6. Walk around to opposite side and repeat
procedure for remaining lift arm and hitch pin.
7. Extend or retract 3-point top link to align its end
hole with the holes of the mower’s top link. Insert
the top link hitch pin and insert retaining pin into
hitch pin.
8. Adjust any lower link check chains, guide blocks,
or sway blocks to prevent the mower from swaying
side to side and possible contact with tractor rear
tires.
Note: Offset Adapter Hitches are available to position the mower to the left or right. Mowers with Offset Adapter
hitches connect to the 3-Point hitch the same way as the mower A-frame. Mowers with a Cat I hitch will be offset
approximately 13” with the use of this accessory. See Offset Adaptor Hitch in the Assembly Section for details to
equip the mower with this feature.