Fuerst FB42, Руководство оператора

Страница: 12 / 82

Safety Section 1-8 FB42 08/01
© 2004 Alamo Group Inc.
SAFETY
SAFETY
WARNING! Mow at the speed that you can safely operate and control the tractor and mower. Safe mowing
speed depends on terrain condition and grass type, density, and height of cut. Normal ground
speed range is from 0 to 5 mph. Use slow mowing speeds when operating on or near steep slopes,
ditches, drop-offs, overhead obstructions, power lines, or when debris and foreign objects are to
be avoided.
(SGM-7)
WARNING! Avoid mowing in reverse direction when possible. Check to make sure there are no persons behind
the mower and use extreme care when mowing in reverse. Mow only at a slow ground speed where
you can safely operate and control the tractor and mower. Never mow an area that you have not
inspected and removed debris or foreign material.
(SGM-8)
WARNING! Do not put hands or feet under mower decks. Blade Contact can result
serious injury or even death. Stay away until all motion has stopped and
the decks are securely blocked up.
(SGM-9)
DANGER! Replace bent or broken blade with new blades. NEVER ATTEMPT TO STRAIGHTEN OR WELD
ON BLADES SINCE THIS WILL LIKELY CRACK OR OTHERWISE DAMAGE THE BLADE
WITH SUBSEQUENT FAILURE AND POSSIBLE SERIOUS INJURY FROM THROWN BLADES.
(SGM-10)
DANGER! Rotary Mowers are capable under adverse conditions
of throwing objects for great distances (100 yards
or more) and causing serious injury or death. Follow
safety messages carefully.
STOP MOWING IF PASSERSBY ARE
WITHIN 100 YARDS UNLESS:
-Front and Rear Deflectors, Chain Guards, or Bands are installed and in good, workable
condition;
-Mower sections or Wings are running close to and parallel to the ground without exposed
Blades;
-Passerby are outside the existing thrown-object zone;
-All areas have been thoroughly inspected and all foreign material such as rocks, cans,
glass, and general debris has been removed.
NOTE: Where there are grass and weeds high enough to hide debris that could be struck
by the blades, the area should be: inspected and large debris removed, mowed at an
intermediate height, inspected, closely with any remaining debris being removed, and
mowed again at desired final height. (This will also reduce power requiredto mow, reduce
wear and tear on the Mower drivetrain, spread cut material better, eliminate streaking, and
make the final cut more uniform.)
(SRM-1)
WARNING! Do not mow with two machines in the same area except with Cab tractors with the windows closed.
(SGM-11)