Fuel LB 100, Руководство пользователя

Страница: 32 / 44

32
User-defined programs U1 to U3
The device offers 3 user-definable programs, where you can create and store your own
programs.
Press “PROGRAM” button in standby mode to select one of the 3 possible user
programs (U1 to U3). Press “MODE” button to confirm. Now set the speed and incline for the first
of ten sections with the handrails buttons (speed “+” and “-“ buttons on the right handrail and
incli
ne “+” and “-“ buttons on the left handrail). Press “MODE” button to confirm and proceed to
next section. After finishing the data input for all 10 sections, the computer will save the data
under the selected User-Program (U1, U2 or U3).
To start a user-defined program, just select the U1, U2 or U3 program and press the
START-button.
AUX, USB Interface and Bluetooth
®
You may connect an external audio device to the AUX connector on the device. Music can only
be played, when the power is switched on and the device is not in sleep mode. The volume can
only be controlled via the connected device.
The USB interface is suitable for charging function purpose only.
The computer supports Bluetooth
®
transmission for MP3 music. After successful pairing, you
may play music via the integrated speakers.
Change unit of measurement (metric / inch)
Press START button, take off the safety clip and put in on its place again shortly afterwards. The
computer will switch into the unit of measurement mode. Use the “+” and “-“ buttons on the right
handrail to select the desired unit (“SI” = metric system / “Eng” = inches). Press START again to
confirm and leave the setting mode.
Parameter settings
Take off the safety clip, press STOP-
and “Speed3” buttons and put back the safety clip.
The computer will enter parameter setting mode according to the following table. Press START
button to display parameter numbers 0
– 9, use the “+” and “-“ buttons on both sides of the
handrail to modify the numbers. NOTE: These parameters should only be changed if you are
instructed to (e.g. from customer service) as the correct settings need expert knowledge about
the functions of the device.
Setting no. Parameter description
Setting range
1 Lowest speed
3 - 30
2 Highest speed
80 - 250
3 Highest incline
12 - 20
4 Speeding up time / km
2 -200
5 Speeding down time / km
2
– 200
6 Low speed transmission ratio
100 - 2000
7 Medium speed transmission ratio
100
– 2000
8 High speed transmission ratio
100
– 2000
9 Automatic transmission ratio
0 - 6000