ASSEMBLY INSTRUCTIONS
Attaching the rear brace
a)
Attach the bungee hook mount (5) to the
underside of the rear brace (3) using the pre-
installed screw. Note that the orientation of the
brace and the hook must be correct, see
illustration below.
b)
Then connect the two slide rails (2) and the rear
brace (3) using the screws (14) and washers (10).
Do not tighten too much! Note: The stoppers point
to the inside of the rail
Seat assembly
The seat (4) is mounted between the slide rails (2).
To do this, carefully push the slide rails apart a little
if necessary and insert the seat. Pay attention to
the correct alignment.
WARNING!
Make sure that the rear
brace is aligned
correctly!
Needed parts:
- Slide rails (2)
- Rear brace (3)
- Bungee hook mount (5)
- 4 x washer 8mm (10)
- 4 x screw M8 x 35mm (14)
Back side
Pre-installed
screw
Hook mount
Screw
(14)
Washer
(10)
Seat
Needed parts:
- Slide rails (2)
- Seat (4)
Slide rails
31