16
2. Preparations
Loosen the two cross-head screws (Figure
3/Pos. 1) on the top and the bottom of the
housing upper part and remove it carefully.
The desired satellite signal is switched
on the input of the 1st channel
(Figure 3/Pos. 2 front row) (LNB signal).
The feed-through output (Figure 3/Pos. 3,
back row) has to be connected with the
input of the channel lying next to it. Its
output is connected again with the input
of the next channel. All unused inputs
and loop through outputs should be
terminated with a 75-Ω-terminal resistance.
NOTE
It has to be taken into account that a signal
level of > 55 dBµV must be on at all inputs.
If the signal level gets too small, the signal
must be fed in newly at the next entrance.
It is recommended not to feed
through more than 2 times.
Figure 3: Preparations
1
2
3
1
1
1
