User’s manual · I-PVR ST192 CI HDMI
Technical changes and mistakes reserve
-
16
-
I-PVR ST192 CI HDMI Version en_1.0
FTE Maximal
2. Standard functions
2.1. Switch on the receiver
The receiver has a main switch at the back panel. To switch on, take the switch in position
1
.
Now the receiver begins to run and show information on its display.
2.2. StandBy
To switch the receiver from Standby (sleep mode) to the working mode, press
Orange
Power button on the left corner
at the top of the remote control.
If the receiver had been working before and you did not switch on by main switch, the receiver show the last displayed
channel.
When you press it again, the receiver goes back to the stand by mode.
2.3. Teletext
The button
Text
opens the teletext generator.
Automatically the receiver loads page 100 as standard.
Like in your TV set you can open the pages by pressing the buttons
0-9
.
If you want to open, for example, the page 140, you
have to press the buttons
1
–
4
–
0
.
When you want close the page, press
Exit
.
2.4. MUTE
With this function, you will be able to shut down the audio completely.
To do it, press the button
Mute
and the warning symbol will be displayed.
By pressing again the button
Mute
the function will be disabled.
2.5. Numeric block on remote control
Over the numeric block in the remote control, you can select directly channels the when you know the stored program
place. If you want for example place 23, you have to press the buttons 2 and 3 and after the button
OK
.
2.6. Switch
channels
With the buttons
CH+
/
CH-
or
you can change the channels also.
Press one button for getting one channel up or down.
2.7.
Change between TV- and Radio channels
When you want change between TV and Radio channels, you have to press the button
TV/R
on the remote control.
2.8. Vol+/Vol-
Volume
With the buttons
Vol+ / Vol-
or
you can regulate the audio volume.
To do it, you will see a graphic like the one at the left side.
For using this function properly, you need to make an alignment with you TV set.
Turn off the volume of the receiver. For this, press the button
MUTE
on remote control. Now turn up the volume on TV
until the moment you hear a noise. Now turn down the volume until the noise desapears. Normally this is around 50-
75% of the total volume of the TV set.
2.9.
Stop the functions
With the button
Exit
you can stop functions like channels search or close menus.
2.10. Open Main menu
To open the main menu, you have to press the button
MENU
.
The menu system is made in a tree structure
