10
Video Connection
Step 1: Ensure the digital video/audio source and display are turned off.
Step 2: Manually set the rotary switch to the native resolution of the display if it
is different than the default resolution of 1920x1080P 2ch Audio
(Default setting of “D” on rotary switch).
NOTE: If the native resolution of your display is not listed in the Mode table,
follow the steps for “EDID data saving (Set Mode 0)” below.
Step 2: Connect the HDMI cable and CAT cable to DV-HXT-1 transmitter and
receiver.
Step 3: Connect the power adapter to the DV-HXT-1 transmitter and receiver.
Step 4: Power up the display. Set the display to the correct DVI or HDMI
Source input.
Step 5: Power up the source.
EDID data saving (Set Mode 0)
For Displays with unique resolutions not listed in the table below or if the “Video
Connection” steps above do not produce a usable image follow this procedure:
NOTE: The HDMI input connector on the DV-HXT-1 Transmitter has a dual
function. It is normally used as a source input but is also used to save EDID
information from the Display by following the steps below.
Step 1: Set rotary switch to mode 0.
Step 2: Connect HDMI
Input
port on DV-HXT-1
Transmitter (TX)
unit to the
display.
Step 3: Power up the display and DV-HXT-1
Transmitter
unit.
Step 4: Push the EDID Switch for 2-4 seconds at DV-HXT-1
Transmitter
unit.
Step 5: The EDID green LED will illuminate for about 2-3 seconds if the EDID
was saved correctly.
If the EDID was not saved correctly, the EDID LED will blink 6 times. The
default EDID when it is shipped is 1080p (1920x1080 @60Hz, 2ch audio).
Saving EDID will display the best resolution between the video source and
the display.
