FSK Rhino 232, Руководство по установке

Страница: 27 / 36

The panel has detected a
wireless zone supervision
fault while it was out of
the docking station.
Place the panel in the
docking station.
CAUSE FIX
ERROR DISPLAY
The panel is out of the
docking station while in
normal operation mode. Place the panel in the
docking station.
Wireless zone supervision,
panel battery low or a
GSM low signal fault has
been detected while the
panel was out of its
docking station. Place the panel back in its
docking station.
The panel is not charging
while in the docking
station. This can be due to
a faulty power supply or
AC power failure. Check if the power supply
plug is plugged in
properly into AC mains
supply and that there is
no load shedding in the
area. Check if the power
supply is not faulty.
The panel has detected a
low battery voltage on its
back-up battery. The
back-up battery voltage
has dropped down to
below 3.8V. Place the panel in its
docking station so that it
can recharge the back-up
battery. If it is, make sure
there is power from the
power supply to the
docking station.
Rhino 232 Installation Manual 27 |