FScurtis SEG-10, Руководство оператора

Страница: 34 / 44

CAP881
34
6.4 Air/Oil Separator
The air/oil separator should be changed at 4000 hours, once a year, when there is excessive oil vapor in
the discharge air, whichever occurs first. Higher temperature operation can cause the element to plug
faster. Consistent operation in temperatures over 180
o
F oil discharge temperature, will require more
frequent separator element changes.
DANGER
Hot oil under pressure will cause severe injury, death, or property damage.
Be sure the compressor is shutdown and pressure relieved before attempting to
remove the oil filter, separator, filling oil, or changing the oil.
Separator Filter Replacement
Turn off the unit; disconnect the power, and lockout and tagout to prevent accidental starting.
1. Relieve pressure from entire system.
2. Using a strap wrench, remove the old filter element.
3. Clean the gasket mating surface with a clean rag.
4. Apply a light film of oil to the new gasket on the filter element.
5. Hand tighten the new filter element until the new gasket is seated against the mating surface.
6. Continue tightening by hand an additional ½ to ¾ turn.
7. Reconnect power, reset separator service advisory.
8. Restart the machine and check for leaks.
6.5 Service Kit Part Numbers
Model
Service
2000hr Kit
Service
4000hr Kit
Service
6000hr Kit
Service
8000hr Kit
SEG-5 & 7.5 VGB707 VGB708 VGB707 VGB709
SEG-10 & 15 VGB710 VGB711 VGB710 VGB712
2000/6000 hr Kit = Air Oil Filter
4000 hr Kit = Air Oil Air/Oil Separator
8000 hr Kit = Air Oil Air/Oil Sep Enclosure F
Inlet valve, Thermal valve, MPV kits
Use only genuine FS Curtis replacement parts.
Substitute parts can reduce performance and void the warranty.