2-2
2.1 General (cont.)
CAUTION
The on-site supervisor is responsible for ensuring that operators are made aware of
the inherent dangers of operating a hot oil filter system, particularly the aspects of
oil filtration, and draining/cleaning procedures.
An ON/OFF switch activates/deactivates the
filter pump, and a 7-amp (120V), or 5-amp
(230V) circuit breaker switches the power OFF if
an overload occurs. An internal backup thermal-
overload switch on the pump-motor provides
additional protection.
NOTE
: If the circuit breaker is triggered,
depress the reset button to activate the
circuit after the failure has been
detected and repaired.
2.2 Rating Plate
Information on the rating plate includes model and serial numbers, as well as electrical requirements.
Have the rating plate information handy when communicating with the factory about a unit or
requesting special parts or information. Without this information, proper identification of the unit
cannot be confirmed.
2.3 Pre-Installation
NOTE: Failure to use qualified service personnel will void the Frymaster warranty.
A.
Standards: Usage of this filter unit must be in accordance with all applicable state and local
codes.
B.
Electrical Connections:
PF95LP units require connection to a 120V, 60-cycle, 15-amp
power supply, or a 220V, 50-cycle, 7-amp power supply. Units are equipped with a
grounded male receptacle for use with a 3-wire, 16 AWG power-cord set.
If an
extension cord is required, it must be a three-conductor, grounded power cord of at least 16
gauge.
7-Amp circuit breaker
On/Off Switch
