ELECTRICAL CONNECTION
- AVOID ALL ACCIDENTAL GROUND STARTING. Before connecting the machine, verify that all the elements
of the machine are properly placed; otherwise it could cause a breakdown.
-CHECK THAT VOLTAGE OF ELECTRICAL NETWORK is the same as the one shown in the identification
sheet of the machine.
- THE CONNECTION INSTALLATION should possess differential protection and own thermal magneto, also
protectec upstream.
-DO NOT START THE MACHINE IF THE ELECTRIC CABLE OR PLUG ARE DAMAGED.
- CONNECT THE PLUG to the electrin network ( 230 - 110 v)
Note: Make sure that the ground connection is propely done and according with the valid standards.
ON AND OFF
- Check that all the elements of the machine are in good position and that the machine's plug is
connected to the electric network of ( 230-220-110v)
- The switch button is located in the rigt side of the machine; to switch it in press the button in a way
that the circle is in the area that stands out (FIG.1)
- To stop the machine, press the switch in a way that the line is in the area that stands our ( FIG.1)
ON
OFF
off
on
( FIG.1)
EN
21
