HOW TO REMOVE THE COVERS
To access the drive system or the engine, the covers must be
removed as follows:
HOW TO REMOVE THE TOP COVER
1. Remove the
discharge chute
. See “How To Remove The
Discharge Chute”.
2. Remove the fuel cap.
3. Remove the two
bolts (A)
and nuts from the front of the
top
cover
.
4. Remove the two
bolts (B)
and nuts from the left and right side
of the
top cover
.
5. Remove the eight
screws (C)
on the left and right side of the
top cover
.
6. Remove the five
screws (D)
from the top portion of the con-
trol panel.
7. Carefully pull the rear of the
top cover
up and over the gas
tank.
8. To install the
top cover
, reverse the above steps.
HOW TO REMOVE THE BELT COVER
1. Remove the
bolts (E)
and nuts that hold the
belt cover
to the
auger housing.
2. If the top cover has not been removed, then remove the
screws (C)
that attach the
belt cover
to the
top cover
.
3. Remove
screw (F)
that holds the
belt cover
to the
bottom
cover
.
4. To remove, hold the bottom portion of the
belt cover
and pull
down and out.
5. To install the
belt cover
, reverse the above steps.
MAINTENANCE
21
Top Cover
Belt Cover
Figure 19
A
B
B
C
C
C
C
D
C
B
A
E
F
Содержание ST0522
Страница 1: ...OPERATOR S MANUAL SNOWTHROWERS ST0522 MT1740284 Rev 01 TP 100 4363 01 SW T...
Страница 29: ...NOTES 29...
Страница 30: ...NOTES 30...
Страница 32: ......
