Frontier ST0522, Руководство оператора

Страница: 10 / 32

Attach Auger Drive Cable
1. Attach the auger drive cable to the auger drive lever using
the “Z” hook (Figure 4).
Adjust The Upper Chute
1. Remove the T-knob and bolt on the upper chute (Figure 5).
2. Rotate the upper chute to the operating position (past the
lower chute stop).
3. Install the bolt and tighten the T-knob .
Figure 5
Lower Chute
T-Knob
Upper Chute
Figure 4
Auger
Drive Lever
“Z” Hook
ASSEMBLY
10
ENGINE
Add Engine Oil
1. The snowthrower was shipped with a container of 5W30
engine oil. Before operating, add this oil to the engine.
2. Remove the oil fill cap/dipstick access panel .
3. Remove the oil fill cap/dipstick (Figure 6). Fill to the FULL
mark on the oil fill cap/dipstick . Periodically check the oil
level. DO NOT OVER FILL.
Install Fuel Cap
If not installed, install the fuel cap onto the fuel tank (see Figure
6).
Add Fuel
1. Fill the fuel tank with fresh unleaded fuel.
2. To extend the life of the fuel and prevent
starting problems, add the fuel stabilizer
supplied with the snowthrower. DO NOT
OVER FILL.
Figure 6
Fuel Cap
Oil Fill Cap/Dipstick
NOTE: Oil level must be at FULL mark.
Access Panel
IMPORTANT! BEFORE YOU START OPERATING
■ ■
Check the fasteners. Make sure all fasteners are tight.
■ ■
On electric start models, the unit was shipped with the starter
cord plugged into the engine. Before operating, unplug the
starter cord from the engine.
NOTE: This snowthrower was shipped WITHOUT OIL in the
engine. See “Add Engine Oil” instructions in the Assembly
section of this manual before starting engine.