1. Run a chain or strap from the top of the bridle mast to the first frame cross member to keep
the bridle from falling forward while working on the disk. A preferred method is to place the
pin in the clevis at the top of the mast and the pin in the clevis on the frame cross member. It
is then possible to run a light chain or a strap around the pins. This will help prevent damage
to the paint. Ideally the bridle mast should be held at a 90 degree angle to the top of the
frame.
2. Use a chain or strap around the frame and the leg of the transport to keep the transport from
dropping when the frame is lifted ( see 3 ). If using a chain, place rubber or matting under
the chain to prevent damage to the paint.
3. Lift the back of the disk high enough to mount the tires on the hubs. One method is to place
the forks of a forklift under the rear cross member.
4. Install the hub spindles into the axle pipes and install retainer bolts. Mount the tires and
wheels on the hubs and tighten the wheel lugs in the sequence illustrated.
25
