Fronius TransSteel 3000c Pulse, Руководство по эксплуатации

Страница: 81 / 140

TIG welding
Safety
WARNING!
Danger due to incorrect operation.
This can result in severe personal injury and damage to property.
▶
Do not use the functions described here until you have fully read and understood the
Operating Instructions.
▶
Do not use the functions described here until you have fully read and understood all
of the Operating Instructions of the system components, especially the safety rules.
WARNING!
An electric shock can be fatal.
If the power source is connected to the grid during installation, there is a danger of seri-
ous personal injury and property damage.
▶
Only carry out work on the device when the power source's power switch is in the -
O - position.
▶
Only carry out work on the device when the power source has been disconnected
from the grid.
Preparation
1
Set the power switch to - O -
2
Unplug mains plug
3
Removing a MIG/MAG welding torch
4
Disconnect the grounding cable from the (-) current socket
5
Insert the grounding cable into the (+) current socket and lock
6
Connect the other end of the grounding cable to the workpiece
7
Insert the bayonet connector of the TIG welding torch into the (-) current socket and
twist it clockwise to lock
8
Screw the pressure regulator onto the gas cylinder (argon) and tighten it
9
Connect the gas hose to the pressure regulator and the TIG gas connection to the
power source
10
Insert mains plug
81
EN-US