Fronius TRANS STEEL 3500 C0MPACT, Инструкция по эксплуатации и список запасных частей

Страница: 86 / 112

84
Exiting the Level 2 set-up menu
Exiting the set-up menu
Welding parame-
ters for MIG/MAG
welding in the
Level 2 set-up
menu C-C
Cooling unit control
Unit: -
Setting range: Aut, On, Off
Factory setting: Aut
Aut: The cooling unit cuts out after a 2-minute welding off-time.
IMPORTANT! If the coolant temperature and flow monitoring options have been
installed in the cooling unit, the cooling unit cuts out as soon as the return-flow tem-
perature drops below 50°C, but at the earliest after a 2-minute welding off-time.
On: The cooling unit is permanently switched on
Off: The cooling unit is permanently switched off
IMPORTANT! If the FAC welding parameter is used, the C-C parameter is not re-
stored to the factory setting. If the MMA welding process is selected, the cooling
unit is always switched off, even if the switch is in the "On" position.
C-t
Cooling time - time from when the rate-of-flow watchdog trips until output of the "no
| H2O" service code. For example, if there are air bubbles in the cooling system,
change the value of the set-up parameter using the "Dynamic"
button or the right adjusting dial
9
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process" buttons
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process" buttons
10
11
12
13
14
15