Fronius TRANS STEEL 3500 C0MPACT, Инструкция по эксплуатации и список запасных частей

Страница: 83 / 112

81
g
Factory setting: Aut
Ito
Ignition time-out - length of wire that is fed before the safety cut-out trips
Unit: mm (in.)
Setting range: Off, 5 - 100 (Off, 0.2 - 3.94)
Factory setting: Off
FAC
Reset power source to factory setting
Press and hold down one of the "Dynamic" (manual control panel) or "Parameter
Selection" (Synergic A control panel) buttons for 2 s to restore the factory settings.
- when "PrG" is shown on the digital display, the power source has been reset.
IMPORTANT! When the power source is reset, all the personal settings in the set-
up menu are lost.
When the power source is reset, operating points that were saved using the "Save"
buttons are not deleted, but are retained in the memory. The functions in the sec-
ond level of the set-up menu (2nd) are also not deleted. Exception: Ignition time-
out (ito) parameter.
2nd
second level of the set-up menu (see "Set-up menu - Level 2")
NOTE! The "Ignition time-out" function (ito) is a safety function. The length of
wire that is fed before the safety cut-out trips may differ from the pre-set wire
length, particularly when the wire is being fed at fast wire feed speeds.
The "Ignition time-out" function (ito) is explained in the "Special functions and
options" section.