Fronius CMT 4000 Advanced, Руководство по эксплуатации

Страница: 128 / 212

Jobs are retrieved in the job mode process.
1
Use the adjusting dial to select the desired job
MIG/MAG jobs can also be selected via the JobMaster or Up/Down welding torches.
When you retrieve a job directly from the power source, you can also select vacant
program locations (symbolised by “- - -”). Only pre-programmed program locations
can be selected via the JobMaster or Up/Down torches, however.
To view the settings for the selected job, use the "Parameter selection" buttons. The
settings cannot be modified. The process and operating mode of the stored job are
also displayed.
2
Start welding
Welding takes place with the welding parameters stored in the job.
During welding you can switch to another job without stopping (e.g. in robot opera-
tion).
When you change to another process, Job mode is ended.
Copying/overwrit-
ing a job In Job mode you can copy a job that has already been saved to one program location to
any other program location. To copy a job, proceed as follows:
1
Use the adjusting dial (1) to select which job you want to copy
2
Briefly press the Store button to change to the job menu
The first vacant program location for the job to be copied is indicated.
3
Select the desired program location with the adjusting dial, or else leave the sugges-
ted program location unchanged.
128
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044